LIFELINE MEASUREMENTS​ FORM

FORMS FOR SUBMIT MEASUREMENTS ONLINE

Both sides of your lifelines will need to be measured as they are usually different. Use a measuring tape that is long enough to measure the span between bow and stern pulpits. Start at the bow with the tape on the bearing point of the pulpit eye. The bearing point is the surface that the pin rests on inside the eye. Run the tape down the side, outside of the stanchions, keeping it at the same height as the lifeline. End at the bearing point of the eye that is at the stern. Measurements should be to the nearest ¼ inch.
On each form there is a diagram that identifies each measurement that is required. Select the form that represents your boat: no gate, aft gate, or mid-ship gate.

NO GATE PDF FORM

STARBOARD




PORT


ADDITIONAL INFORMATION





Should read: Your information is secure and will not be sold or shared.

AFT GATE PDF FORM

STARBOARD






PORT




ADDITIONAL INFORMATION





Should read: Your information is secure and will not be sold or shared.

MID-SHIP GATE PDF FORM

STARBOARD








PORT






ADDITIONAL INFORMATION





Should read: Your information is secure and will not be sold or shared.